The initial setup is straightforward. In our segment, for instance, it can typically be completed within an hour. However, the total time depends on the number of equipment pieces.

The initial setup is very easy and the setup wizard allows us to do the first steps in a few minutes. DNS and DHCP services in a nework is a must to go through easy setup mode. The quick configuration guide is easy to use.

Alcatel-Lucent OmniAccess Stellar's initial setup took less than half an hour.

The installation is straightforward and although it is not complicated, we need to have the proper expertise. If somebody doesn't know this product then it will be very complex. That's why we have people who are trained on the product and have certifications from the vendor.

For people that are certified, the setup is easy. This is the same case with other vendors; those who are trained on the product can configure it. It depends on the technician's expertise.

The initial setup of the solution is easy.

It is an easy installation. It takes about two days to install and implement. As long as you plan for the configuration, you are fine.

A little bit complex, because the devices have a big set of caveats that are mandatory to deploy.

Simple, straightforward and easy to understand.

The solution offers a pretty simple setup. It's not overly complex or difficult. A company shouldn't have any issues with the process. However, it does depend on the organizational requirements.

The time it takes to deploy the solution also varies. A smaller setup, for example, may only take about two days. However, a larger setup could take longer.

Today the setup is very easy, you can use a web browser and just follow the steps. I remember that in 2009, it was a little complex, but not too hard. You had to start the AP by CLI and choose the language for use (only English, German, and French were available) and select the country where you were using the system. Then all configurations were done by CLI.

Straightforward but very simple possibilities.

We used the wizard for initial configuration and it was straightforward.