The initial setup is straightforward. It's plug-and-play and ready to go out of the box. There is no staff required for maintenance. 

The setup is straightforward. We just use the graphical interface. We don't have to use a lot of commands.

The installation and deployment process is very easy, requiring minimal effort.

The initial setup is straightforward.

It took more than two months to complete our deployment, as we have a large organization.

The initial setup of D-Link Ethernet Switches is very easy.

I rate the setup of D-Link Ethernet Switches a five out of five.

The tool is easy to implement. 

The solution's initial setup is very easy.

The initial setup is easy and takes less than a day to complete. One person is enough for the solution’s installation.

The solution’s initial setup process is straightforward. It has a simpler user interface that makes the process easier. Although, it requires assistance from a professional if you don’t have prior experience working with it. In the case of a proper network design, deployment takes a day. However, it largely depends on network size. It took a week for us to complete it.

They are easy to install. It takes less than 20 minutes.

Deploying D-Link switches is straightforward. You can install and configure a switch in around 15 minutes. There are two ways you can configure a switch. You can use the default interface on each switch or you can configure the switches with a management tool from one computer. It's much easier to use a utility because you don't have to configure each switch separately. 

You don't need a consultant or integrator. It's easy to set up the switches yourself. The technical team lays the cable and mounts the hardware, and I handle the deployment and configuration alone. 

The initial setup was quite straightforward. It took two days at most.

The initial setup is straightforward. It has good documentation that is easy to read and understand. To deploy, we have to configure the solution.

The initial setup is very easy and I've had no issues with it at all. Once all of the cables were in place and we turned it on, it worked right away. I had one core switch, to which all of the other switches and the firewall were connected.

The initial setup is very easy — plug and play and it works all the time.

The initial setup is better than other switches as it has a multiple-degree interface. The CLI is just one. Not all the switches have a degree interface, whereas most of the D-Link switches do, at least, in terms of the managed switches.

We provide maintenance and support to our clients as needed.

The initial setup was very easy and user-friendly. Because we use it for only the access layer, it takes about 30 to 40 minutes to deploy.

The installation is simple, it takes approximately 10 minutes. All you need to do is install the equipment, connect the power, and network cable. It is mostly plug and play, you do not need to configure it. 

We have been using the solution for upwards of 10 years and so far so good. However, the majority of our switches are 100 Mbps, so we're looking to upgrade to one gigabit.

The initial setup is very straightforward and simple. We didn't find the process to be overly complex or difficult. 

Usually, the deployment doesn't take very long. It's a quick implementation.

We don't install it ourselves.