The deployment process, taking one to two hours, involves careful setup of the router and switches. Key considerations include choosing the appropriate port on the router for internet cable connection, connecting network cables to a patch panel for switches, and linking them to each core. Utilizing crucial ports, like the FortiGate Apollo with higher bandwidth, is emphasized. Following physical connections, the PC is powered on, and the network management console is accessed. The router requires extensive configurations, and each switch port must be assigned specific tasks.

We were able to complete the deployment ourselves.

We do it in-house. We set out a plan, and our technicians take care of setting up the units and putting them online. We often have a senior technician do the final tuning. We have three senior technicians and a couple of junior technicians who help out.

I set up some protocols by myself, and for some others, we took vendor or IT help. I manage the router for internet, bandwidth, data link, and also for the IT platform.

Sometimes it becomes complex, and in such cases, I take help from IT. But it seems to be easier because we always have the interface to run Winbox and monitor how much data is flowing through each port.

Also, if any port needs maintenance, we can easily check if it is disconnected or not. Even if it's physically connected but not functioning properly, it can be easily identified using MikroTik Toolbox.

It is deployed on-premises. And it is only hardware. It uses the Winbox software for the router. It is not cloud-based and is not used for security or other purposes. Its sole purpose is to maintain the data link and internet connection.

We took only a few minutes to install the product. We install and configure the solution for our customers. We also provide support and maintenance to customers.

We don't need a consultant for the deployment. A lot of information can be found on the web. 

An in-house team implemented MikroTik Routers and Switches with a lot of guidance from the ISP.

When I deployed it, I was a technical person at the time. I could do it by myself without assistance.

I implemented this solution by myself with the help of my team.

I set it up myself. I didn't have any help from third-party consultants or integrators. 

I take help from an IT executive whenever I encounter any implementation issues.

We initiated the assistance of a consultant and they proved to be quite helpful. 

Our in-house team is responsible for deployment and maintenance. We have approximately 35 people on our team.

Our technician performs the deployment for our customers.

I implemented this solution in universities, banks, and commercial centers. We have two or three people in charge of deployment and maintenance. 

I handled the implementation myself. I didn't need the assistance of an integrator or reseller.

I did the implementation of the solution myself.

I handled the implementation myself, in-house. I did not need the assistance of an integrator or consultant when I deployed it. 

We implemented this solution through an in-house team. 

The implementation can be done without the help of a consultant. You can do it on your own.

We can handle the deployment for customers.

I handled the implementation myself.

The implementation was done by my team.

Our in-house team deployed our routers.

In-house, it was more of a trial and error but finally got it. We still and constantly improving our know how but we will get there.

I performed the deployment myself.

I have done the implementation of the solution. There are times where I need an additional technician to assist me.

We have our own small team that handled deployment.

I installed it myself.