OmniPeek Initial Setup
The initial setup of OmniPeek is easy. You download an executable file from the internet, install it, then provide the licensee you were given. Additionally, you can install it on servers, give the IP addresses and it will run it.
View full review »SS
Shah Sachinkumar
Lead Engineer at NXP Semiconductors
The initial setup is not difficult. In some other scenarios, somebody should be there. Sometimes the interface was not detecting and we needed to restart. Doing that requires going to the network manager, and again we needed to restart. In fifteen to twenty minutes you can have the software installed and be up and running.
KY
Kobe Yu
Engineer at Lite-On Technology Corp
This product is easy to implement.
To implement the solution takes one hour since the key part for us is finding the right wireless link to support OmniPeek to capture the wireless traffic. So as long as you are working in this field, you know what wireless card you need to use and what driver to install. That's the hard part. If you have related experience in the field, one hour is good enough in terms of getting it set up.
View full review »Buyer's Guide
Application Performance Monitoring (APM) and Observability
April 2024
Find out what your peers are saying about LiveAction, Riverbed, New Relic and others in Application Performance Monitoring (APM) and Observability. Updated: April 2024.
768,857 professionals have used our research since 2012.
The initial setup of OmniPeek was easy. The solution can capture all of the packets within two or three minutes.
View full review »The initial setup was straightforward and very easy to install.
View full review »Buyer's Guide
Application Performance Monitoring (APM) and Observability
April 2024
Find out what your peers are saying about LiveAction, Riverbed, New Relic and others in Application Performance Monitoring (APM) and Observability. Updated: April 2024.
768,857 professionals have used our research since 2012.