When I started using RapidMiner, I found it difficult to get it to read the metadata. I wanted to use, for example, a pivot table, and it did not have the variable or the attribute names in it. There were no values. It took a long while to figure out how to do that, although it tends to do it automatically nowadays. RapidMiner is not utterly intuitive for beginners. Sometimes people have trouble distinguishing between a file in their own file system and a repository entry, and they cannot find their data. This is an area where this solution could be improved. It would be helpful to have some tutorials on communicating with Python. I found it a bit difficult at times to figure out which particular variable, or attribute, is going where in Python. It is probably a simple thing to do but I haven't mastered it yet. I'd like them to do a video on that. There are a large number of videos that are usually well-produced, but I don't think that they have one on that. Essentially, I would like to see how to communicate from RapidMiner to Python and from Python to RapidMiner. One of the things I do a lot of is looking at questionnaires where people have used Likert-type scales. I don't recommend Likert-type scales, but if they're properly produced, which is a lot of hard work and it's not usually done, they're really powerful and you can do things like normalizing holes on the Likert scale. That's not the same as normalizing your data in RapidMiner. So, I would want to get results with these Likert scales, pass it through RapidMiner, do a normalization and pass back both the raw scores and the normalized scores and put in some rules, which will say if it's high on the raw score and on the normalized score and low on the standard deviation, then you can trust it.